Silvercrest SHMS 300 A1 - Manual (Page 7)

- 5 -
Warning:
Under no circumstance should you use receptacles
made of glass or other very fragile/easily breakable
materials. These containers can be damaged and
then cause potentially serious injuries.
9. Insert the plug 3 into a mains power socket.
10. To set the mixer into motion, push the speed
switch 1 to the desired speed setting. You
can select between 5 speed settings or the
turbo button 0 (see section "Speed levels").
Warning:
Do not operate the mixer for longer than 10 minutes
in one session. After 10 minutes, allow the appliance
to rest until it has cooled itself down.
Note:
If ingredients become stuck to the side of the mixing
bowl 7 and they cannot be captured with the
kneading hooks r/ whisks e, switch the hand mixer
off. Remove the lid 9. Use the dough scraper t to
push them back into the middle of the mixing bowl 7.
Replace the lid 9. Switch the hand mixer back on.
11. To remove the bowl contents, switch the appli-
ance off. Pull the lid 9 to the side and remove
it. Press the release button for tilting 5, lift the
holder upwards and remove the mixing bowl 7
from the mixing stand 6.
Note:
In the case of larger amounts in the mixing bowl 7,
it is to be recommended that you first remove the
mixer from the holder.
12. Press the release button 4 to remove the hand
mixer and the ejection button q to release the
whisks e or the kneading hooks r.
Note:
For safety reasons, the whisks e or the dough
hooks r can only be released when the speed
switch 1 is in the position "0" or " " shows.
Blending
Warning:
Never use the blender w for hard foodstuffs such as:
coffee beans, ice cubes, sugar, cereals, chocolate,
raw/hard vegetables etc. They could cause serious
damage to the appliance.
Warning:
Under no circumstance should you use receptacles
made of glass or other very fragile/easily breakable
materials. These containers can be damaged and
then cause potentially serious injuries.
1. Open the fixture for the blender 2 and hold the
safety cover 2 firmly.
Note:
The blender w can only be utilised when the whisks
e or the kneading hooks r are not installed.
2. Insert the blender w until it engages and then
twist it firmly tight.
3. To avoid overflows, the container used for blending
should only be filled to 2/3rds of its capacity.
Select a sufficiently large container.
Tips:
• To ensure an effective blending of the ingredients,
the foodstuffs to be processed should cover at
least the lower section of the blender w.
• First switch the hand mixer on when the blender w
has been inserted into the ingredients to be
blended.
IB_53198_SHMS300A1_LB4 28.05.2010 13:59 Uhr Seite 5