Silvercrest Z28414 - Manual (Page 36)

36 GB/MT
Before getting started / Preparing for use
note: The control unit must not be mounted
more than 1.5 m away from the scales. Other-
wise no infrared connection can be established.
3. Mark the selected position with a pencil.
4. Use a drill to drill a hole in the wall. Please comply
with the operating and safety instructions of the
drill.
5. Place the dowel into the hole.
6. Screw the screw into the dowel. Make sure that
the head of the screw sticks out of the wall by
5 - 7 mm.
7. Hang the control unit onto the wall using the
mounting device 12 .
Q Preparing for use
Q Setting the time
1. Press the time / confirmation button 7 down for
about 3 seconds to be able to set the hours.
note: The hour display will flash.
2. Press the count-up button 8 or the count-down
button 9 to set the hours.
3. Press the time / confirmation button 7 to confirm
the entry and to be able to set the minutes.
note: The minute display will flash.
4. Press the count-up button 8 or the count-down
button 9 to set the minutes.
5. Press the time / confirmation button 7 to confirm
your entry.
Q Setting the alarm
1. Press the alarm-setting button 8 twice to activate
the alarm and to display the alarm time.
note: When the alarm is activated, the symbol
18 will appear in the LC display 11 .
2. Press the confirmation button 7 down for
about 3 seconds to be able to set the hours.
note: The hour display will flash.
3. Press the count-up button 8 or the count-down
button 9 to set the hours.
4. Press the confirmation button 7 to confirm the
entry and to be able to set the minutes.
note: The minute display will flash.
5. Press the count-up button 8 or the count-down
button 9 to set the minutes.
6. Press the confirmation button 7 to confirm the
entry.
7. Wait for about 30 seconds or press the confir-
mation button 7 again in order to get back to
time display.
8. Press the alarm-setting button 8 twice to
deactivate the alarm.
note: When the alarm is deactivated, the
symbol
18 in the LC display 11 will go out.
The alarm time will go out.
9. Press the time / confirmation button 7 in order
to get back to time display.
Q Setting the unit of weight
note: the legal weight unit is kg.
note: You can choose to display the units of weight in
either kilogrammes or “stones and pounds” or pound.
note: When the unit of weight is changed, the unit
of measurement for height also changes.
1. Pick the control unit up.
2. Make sure that the time is being displayed and
press the button to set the units of weight /
count-down button
9 .
3. Press the time / confirmation button 7 down
for about 3 seconds to be able to set the units
of weight you wish to have.
note: The pictograms of the units of weight
20 , 21 will flash on the right-hand side of the
LC display 11 .
4. Press the count-up button 8 or the count-down
button 9 to set the unit of weight.
5. Press the time / confirmation button 7 to
confirm your entry.
6. Wait for about 30 seconds or press the time /
confirmation button 7 again in order to get
back to time display.
Q
Entering personal details
1. Pick the control unit up and make sure that the
time is being displayed.