Silvercrest SKW 3 EDS A1 - Manual (Page 8)

- 6 -
Notice
You can repeat this procedure several times.
However, never place more than 5 kg on the scale.
On removal of the receptacle and ingredients from
the scales, and on pressing the button Z/T 4, “O”
is once again indicated on the left in the display 6.
Removing weighed items
Press the button Z/T 1) 4 once. In the display
6 “TARE” is shown on the left. The scales
indicate a weight of “0” again.
Remove the desired amount of item. 2)
The weight value of the removed item appears in
the display 6 as a negative value.
Notice
You can repeat this procedure several times.
With removal of the receptacle and ingredients
from the scales, and on pressing the button Z/
T 4, “O” is once again indicated on the left in
the display 6.
Setting the Timer
The timer can be used in both the clock and the
weighing mode.
The timer enables you to set the clock for a specifi c
period of time, at the end of which a signal tone
sounds. The preset time runs as in a countdown
Press the button T-SET 1) 7 once. In the display 6
the bell symbol appears .
Notice
You can adjust the time accurately to the second.
If you press and hold down the button ▲ Z/T 4
resp. ▼ UNIT 8 the time-indicator fi gures run
through faster.
Using the buttons 2) ▲ Z/T 4 resp. ▼ UNIT 8,
programme in the desired ten-minute setting.
Press the button T-SET 3) 7 once. Using the but-
tons ▲ Z/T 4 resp. ▼ UNIT 8 , programme
in the desired one-minute setting.
Press the button T-SET 4) 7 once. Using the but-
tons ▲ Z/T 4 resp. ▼ UNIT 8, programme
in the desired ten-second setting.
Press the button T-SET 5) 7 once. Using the but-
tons ▲ Z/T 4 resp. ▼ UNIT 8, programme
in the desired one-second setting.
Press the button T-SET 6) 7 to start the count-
down.
Notice
You can reset the timer: Press the button T-SET 7
to reset the timer.
As soon as the programmed time has expired, an
acoustic signal sounds. This signal can be switched
off by pressing any button.
Switching the weighing function
off
If you do not weigh anything for ca. 2 minutes the
scale automatically switches into the clock mode.
• To switch over to the clock mode manually, press
the button ON/OFF 5.
Temperature Display
In the display 6 the temperature is shown on the
bottom right in °C.
IB_64679_SKW3EDSA1_LB4.indb Abs1:6 IB_64679_SKW3EDSA1_LB4.indb Abs1:6 16.05.2011 8:51:54 Uhr 16.05.2011 8:51:54 Uhr