Silvercrest SDBE 2400 A1 - Manual (Page 50)

48 GB
• The integrated anti-limescale protection
reduces limescale deposits for average
water hardness, and thus extends the
service life of the device. If your tap wa-
ter is hard, use distilled water. Where
the water is moderately hard, mix dis-
tilled water and tap water at a ratio of
1:1.
1. Disconnect the mains plug|9 from the
wall socket.
2. Turn the steam flow rate controller|3 left
to 0.
3. Open the lid|2 (of the water tank) and
hold the device at a slight angle to fill it.
4. Use the measuring beaker|20 to pour in
water up to the mark|18 max, but at
least up to one quarter. Hold the steam
iron upright to check.
5. Close the lid|2 (of the water tank).
6. Put down the steam iron in an upright
position.
6.2 Set iron temperature
1. Set the desired temperature using the
temperature controller|16:
- min
the device is not getting hot
- Temperature: up to approx.
110 °C
- Temperature: up to approx.
150 °C
- Temperature: up to approx.
- 210 °C
- max maximum temperature
2. The temperature control lamp|11 is lit
for as long as the steam iron is heating.
It goes out when the set temperature has
been reached. You can then begin iron-
ing.
6.3 Spray function
Use the spray function in order to dampen
dry items of laundry. This option is available
irrespective of the set temperature. For this
purpose, the water tank|15 must be at least
one quarter full.
• Press the spray button|5
repeatedly.
While doing so, hold the steam iron
over the item of laundry. Ensure that no
water sprays onto the ground.
6.4 Ironing without steam
Sensitive fabrics are ironed at lower temper-
atures and without steam. In order to damp-
en them, the spray function is available.
1. Set the steam flow rate controller|3 to 0
and set the temperature controller|16 to
min.
2. Fill the water tank|15 if you wish to use
the spray function.
3. Connect the mains plug|9 with the wall
socket.
4. Set the desired temperature using the
temperature controller|16. The tempera-
ture control lamp|11 lights up.
5. Start ironing as soon as the ironing tem-
perature has been reached|11 and the
temperature control lamp goes out.
6. Finish ironing, set the temperature con-
troller|16 to min and pull out the mains
plug|9.
7. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank|15 through the filling open-
ing in the water tank (under the lid|2).
6.5 Ironing with steam
Steam ironing requires a high temperature,
at least the temperature setting for .
In order to additionally dampen items of
clothing, the spray function is also availa-
ble.
_CPE100696_Dampfbügeleisen_B2.book Seite 48 Freitag, 11. Juli 2014 10:34 10