Silvercrest SIKP 3400 A1 - Manual (Page 59)

57 SKIP 3400 A1
GB
Troubleshooting
PROBLEM POSSIBLE CAUSE
POSSIBLE
SOLUTIONS
The appliance does not
function. The control lamp
On / Standby r does not
glow.
The plug is not connected.
Connect the appliance to
a mains power socket.
The appliance is damaged.
In this case, contact
Customer Services.
The appliance does not
start the cooking process.
There is no cookware on
the respective cooking area
1 2 4.
Place suitable cookware on
the cooking area 1 2 4.
The cookware is not suitable
for induction cooking areas.
Use suitable cookware
(see chapter "Suitable
Cookware").
E01 appears in one of the
displays.
The appliance is not being
supplied with enough voltage
(< 160 V).
Check to ensure that the
appliance is connected to
a properly installed mains
power socket supplying
220 - 240 V ~, 50 Hz.
E02 appears in one of the
displays.
The appliance is being
supplied with too much
voltage (> 270 V).
Check to ensure that the
appliance is connected to
a properly installed mains
power socket supplying
220 - 240 V ~, 50 Hz.
E03 appears in one of the
displays. There is a short circuit inside
the appliance!
Immediately disconnect the
plug from the mains power
socket and contact the Cus-
tomer Services department!
E05 appears in one of the
displays. The appliance is too hot
(in power levels mode)!
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
E06 appears in one of the
displays.
The temperature sensor under-
neath the cooking area 1 2
4 is defective or there is a
short circuit.. Disconnect the plug from
the mains power socket
and contact the Customer
Services department.
E07 appears in one of the
displays. The appliance is too hot
(in Temperature-Mode)!
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
IB_75467_SIKP3400A1_LB5.indb Abs2:57 IB_75467_SIKP3400A1_LB5.indb Abs2:57 11.07.12 14:44 11.07.12 14:44