Silvercrest SBB 850 A1 - Manual (Page 12)

- 10 -
• Briefly press the Start/Stop button
 to interrupt
the programme at the very start of the baking
phase or, remove the power plug from the wall
socket. Ensure that you re-insert the power plug
within 10 minutes so that the baking process can
be continued.
• Open the appliance lid
 and remove the
baking mould
. You can take the dough out
with floured hands and remove the kneading
paddles
.
• Lay the dough back into the baking mould
.
Replace the baking mould
 and close the
appliance lid
.
• Insert the power plug into the wall socket. The
baking programme continues from where it
was stopped.
Allow the bread to cool for 15-30 minutes before
eating it.
Before cutting the bread, ensure that the kneading
paddles have been removed
.
Error Messages
• If the display
 shows "HHH" after the programme
has been started, it indicates that the temperatu-
re in the Bread Baking Machine is still too high.
Stop the programme and remove the power plug.
Open the appliance lid
 and allow the machine
to cool down for 20 minutes before re-using it.
• If a new Programme cannot be started directly
after the Bread Baking Machine has completed
a baking process, it means the appliance is still
too hot. In this case the display panel reverts to
the default setting (Programme 1). Open the ap-
pliance lid
 and allow the machine to cool
down for 20 minutes before re-using it.

Warning!
Do not attempt to take the appliance into use before
it has cooled itself down. This functions only with
Programme 12.
• If the display shows "EE0", "EE1" or "LLL" after
the programme has been started, first of all
switch the Bread Baking Machine off and then
back on by removing and then re-inserting the
power plug from/into the wall socket. Should the
error display continue, make contact with
Customer Services.
Cleaning and Care

Warning!
Before cleaning it, always remove the power plug
from the wall socket and allow the appliance to
cool down completely.
Protect the appliance against moisture, this could
cause you to receive an electric shock.
Please also observe the safety instructions.

Important!
The appliance and its ancillaries are not suitable
for being cleaned in a dish washing machine!
Housing, lid, baking space
Remove all particles left behind inside the baking
area using a wet cloth or a slightly wet soft sponge.
Wipe the housing and the lid too, only with a moist
cloth or sponge.
• Ensure that the interior is completely dry. For
easier cleaning, the appliance lid
 can be
removed from the housing:
• Open the appliance lid
 until the wedge-
shaped hinge cams pass through the openings
of the hinge guides.
• Pull the appliance lid
 out of the hinge guides.
• To reassemble the appliance lid
, guide the
hinge cams through the opening of the hinge
guides.
IB_69294_SBB850A1_LB4 12.08.2011 13:16 Uhr Seite 10