Eurotech Appliances WL1000 - Manual (Page 19)

WL1000 User Manual 19
The I/O interfaces and the Reset button
A waterproof cover on the bottom side of the WL1000 protects the I/O interfaces and the Reset button.
First remove the protective cover by gently pulling on the small tab to the left of the Zypad, as showed
above. This will reveal the following I/O interfaces.
Stereo Jack USB Host Mini-SD Connector USB Device Reset
THE STEREO PORT
It is possible to connect an Earphone to the WL1000 dedicated stereo 2.5mm jack plug.
THE USB HOST PORT
This USB Host port is used to connect peripherals to the WL1000 (the host).
This port can also be used to connect a USB key for upgrading the firmware (for further information
visit:
ftp://zypad:[email protected] )
THE MINI-SD CONNECTOR
Use this connector to insert a standard Mini-SD memory card.
THE USB DEVICE PORT
This USB Device port is used to connect the WL1000 (as a slave device) to a host computer.
It is also used to connect the battery charger (AC adapter).
When the WL1000 is connected as a slave device, the host computer automatically charges the
WL1000 battery.
THE RESET BUTTON
The Reset button allows you to stop all running applications and restart the ZYPAD WL1000. Doing so
will stop all running applications and will erase any unsaved data within running applications. The reset
operation will not erase any program or saved data. We recommend that the user save any data
before resetting the WL1000. Use the stylus to lightly press the Reset button.