Silvercrest SDS 3000 A1 - Manual (Page 8)

6 SDS 3000 A1
GB
Securing devices
NOTICE
This tripod is equipped with a quick release plate ► 2. When a device is
screwed onto the quick release plate 2 you can, by sliding the locking
device 8 on the side of the tripod plate 3, loosen the device together
with the quick release plate 2 from the tripod plate 3. Thus, you do not
always have to unscrew the device from the thread 1.
Remove the quick release plate 1) 2 from the tripod. For this, slide the locking
device 8 to the side so that you can lift the quick release plate 2.
Screw the required device onto the quick release plate 2) 2. To do this, turn
the screw - with the help of the handle on the underside of the quick release
plate 2 - until the device is fi rmly seated.
To replace the quick release plate 3) 2 complete with the device back on
the tripod plate 3, slide the locking device 8 to the side and reposition
the quick release plate 2. Then secure the locking device 8, such that the
quick release plate 2 is fi rmly seated.
Using the tripod
When you have set the tripod up and the device is mounted on it, you can then
adjust it as follows:
WARNING - PROPERTY DAMAGE!
Always hold the grip ► 0 fi rmly when you loosen the locking screw “High”
7 and turn the crank q. Otherwise – if the locking screw “High” 7 is
loosened and the crank q is not fi rmly held - the rod with the attached
device could fall down to the lowest setting and, through it, the device
could be damaged.
Loosen the locking screw “High” ■ 7 to a point where the crank q can be
turned easily. Turn the crank q to adjust the height. When the desired height
has been reached, fi rmly retighten the locking screw “High” 7.
To swivel the device horizontally through up to 360°, loosen the locking ■
screw "360°" 5. Take hold of the grip 0 and swivel the tripod plate 3.
When you have reached the desired position, retighten the locking screw
"360°" 5 fi rmly.
To adjust the tilt angle, rotate the grip ■ 0 and move it either up or down.
When the desired tilt angle has been reached, rotate the grip 0 again until
it is fi rm.
IB_71271_SDS3000A1_LB4.indb Abs3:6 IB_71271_SDS3000A1_LB4.indb Abs3:6 12.10.2011 9:31:37 Uhr 12.10.2011 9:31:37 Uhr