Silvercrest SLS 2000 B2 - Manual (Page 52)

49
Handling and operation
SLS 2000 B2
GB
Handling and operation
Preparation
1. Check the maximum input voltage of the device that you want to charge.
This information can be found in the device’s operating instructions.
2. Ensure that, when using the connector sockets
6
-
8
, the maximum total
power consumption does not amount to more than 1000 mA (about 333 mA
per socket). The USB ports
4
+
5
can each be loaded with 2100 mA.
In this regard, check in the operator manual of the device.
3. Check which adapter cable is required for the device (see the compatibility
table p. 26 - 28).
Charging of 5 V devices
1. Remove the cover from the charging station and then connect the plug of the
appropriate adapter cable into one of the connection sockets
6
-
8
resp. the
iPod/iPhone/iPad cable
22
into one of the USB ports 4 + 5 .
2. Place the cover back on the charging station thereby feeding the adapter
cable through the cut-out on the front panel of the cover.
3. Plug the other end of the adapter cable into the device’s power supply socket.
The device now receives its power supply from the charging station. If the device
has a charge control indicator, this will show that the device is charging.
NOTICE
► This charging station is so powerful that all three connection sockets
6
-
8
and the USB ports 4 + 5 can be used simultaneously. However, the
total power consumption of connected devices may not exceed 5200 mA
(1000 mA in total for connection sockets
6 - 8 and 2100 mA each for
the USB port
4
+
5
).
► When charging, the iPad or other tablets can be inserted into the retaining
device
3 .
Buch_75830_LB2.indb 49 Buch_75830_LB2.indb 49 31.08.12 10:20 31.08.12 10:20