Silvercrest SLS 1000 A1 - Manual (Page 51)

49
Handling and operation
SLS 1000 A1
GB
MT
Handling and operation
Preparation
1. Check the maximum input voltage of the device that you want to charge.
This information can be found in the device’s operating instructions.
2. Make sure that the maximum current consumption does not exceed 1000 mA
(only when using the USB ports
7
) and/or 2000 mA. This information can
be found in the device’s operating instructions.
3. Check which adapter cable is required for the device (see the compatibility
table p. 54 + 55).
Charging of 5 V devices
1. Remove the cover from the charging station and insert the plug of the applicable
adapter cable in one of the connection sockets 3 -
6
and/or the iPod/iPhone
cable
21
into the USB port 7 .
2. Place the cover back on the charging station thereby feeding the adapter
cable through the cut-out on the front panel of the cover.
3. Plug the other end of the adapter cable into the device’s power supply socket.
The device now receives its power supply from the charging station. If the device
has a charge control indicator, this will show that the device is charging.
NOTICE
The charging station is so effi cient that all 4 connection sockets ► 3 - 6 and
the USB port
7
can be used at the same time.