Silvercrest SKT 2000 A1 - Manual (Page 52)

50
If you want the appliance to heat up
particularly quickly, select level 3. If you only
want it to heat up slowly, select level 1.
A red indicator lights up in the activated
switches as soon as the appliance starts to
heat up.
If no switch is pressed, the appliance will not
produce any heat.
6.3 Selecting the temperature
Set the required temperature with the
temperature selector 8.
• When the required room temperature is
reached, slowly turn down the
temperature selector 8 until you hear a
quiet "click".
The red indicators in the switches 5 and
6 will be extinguished.
The current room temperature will be
maintained.
As soon as the appliance needs to heat
up again to maintain the temperature,
the red indicators in the switches 5 and
6 will light up once again in the
meantime.
6.4 Fan function
The appliance is equipped with a fan to
distribute the air more quickly in the room.
To switch on the fan, press the fan switch 7.
A red indicator in the fan switch 7 will then
light up.
Note: The appliance can also be operated
without the fan being switched on. The heat
will then be concentrated more around the
convector and will not be distributed so
quickly in the room.
6.5 Setting the heating time
The appliance has a timer with which you
can set the required heating time.
1. Switch the timer on by
setting the main
switch 11 to the
Clocksymbol.
2. Turn the scale for the
time 13 with the
control segments 14
until the current time
points to the hourly
marking 12.
In this example the time is 03.00 am.
3. Select the times when
the appliance is to
function by pulling up
all control
segments 14 from the
beginning to the end
according to the scale
for the time 13 .
In this example the heating time runs
from 05.00 pm to 10.00 pm.
4. To switch off the timer, move the main
switch 11 to "
I " (continuous) or "0"
(appliance switched off).
6.6 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Set the main switch 11 to "
0" to switch
off the power supply.
2. Make sure that the air can enter and
escape freely.
1 24
23
22
2
1
2
0
1
9
1
7
6
5
4
3
2
0
I
1 24
23
22
2
1
2
0
1
9
1
7
6
5
4
3
2
0
I
1 24
23
22
2
1
2
0
1
9
1
8
1
7
16
15
14 131 21
1
3
2
0
I
RP77967 Konvektor-Timer LB1 Seite 50 Freitag, 20. Juli 2012 7:30 19