Elitegroup TRW-1 - Manual (Page 2)

REV.1/25/05 Page 2 of 9 Part #17810
WALL MOUNTING THE THERMOSTAT
1. The wireless Thermostat must be located within 20’ of the receiver, This is
the normal operational distance.
2. Remove face from backing plate as shown in Figure #1 then locate the (2)
two holes that mount the plate to the wall.
3. After locating the (2) two mounting holes and mark the holes on the wall.
4. Use the (2) two dry wall anchors and screws ( that are supplied) to mount
the base plate to the wall as shown.
5. Thermostat can also be mounted onto an existing (Plastic) electrical box.
6. Base plate should be mounted level on the wall for best operation.
GENERAL INFORMATION
WALL MOUNT THERMOSTAT OPERATION
FUNCTIONS
1. ROOM TEMP – Current room temperature.
2. F – Degrees Fahrenheit (C Indicates degrees Celsius)
3.
FLAME ICON – Indicates APPLIANCE IS ON.
4. SET- Indicates transmitter is in thermostat mode.
5. DASHES – Indicate thermostat mode is being disabled. When
transmitter is not in the thermostat mode. The word (SET) will not appear.
1. This TS/R-2-A Wall/transmitter has ON, OFF, and SET functions that are activated by pressing
the buttons on the face of the transmitter.
2. Upon initial use, there may be a delay of five seconds before the remote receiver will respond
to the transmitter. This is part of the system’s design. If the LCD will not come on, check the
3V-button cell battery.
SETTING MANUAL OPERATION
1. When the ON button on the wall/transmitter is pressed a flame icon on the LCD screen wil
appear when the appliance is ON.
2. When the appliance is OFF the flame icon will not appear.
SETTING THERMOSTAT OPERATION
1. If the transmitter is in the thermostat mode the word (SET) will appear on the LCD screen.
2. When the SET button is pressed the temperature digits will begin to flash.
3. While the temperature digits are flashing use the ON button to increase the set
temperature or
use the OFF button to decrease the set temperature to your desired temperature.
4. When the desired temperature setting is reached press the SET button, again and the
word SET will appear on the LCD screen and now the transmitter will automatically send
an ON or OFF signal to the receiver.
5. To disengage the thermostat mode push the OFF button or push and hold the SET button
until (2) dashes appear on the LCD screen. When you release the SET button this will
disengage the thermostat mode and the word SET will disappear from the LCD screen.
SETTING
0
F /
0
C SCALE
The factory setting for temperature is degrees Fahrenheit (
0
F ) . To change this setting to Centigrade (
0
C ), you must press and hold
both the ON and OFF buttons on the transmitter at the same time until the LCD displays the change. If you want to convert back,
repeat the above procedure.
ROOM TEMP
1 2
3
SET
ROOM TEMP SET
5
4
ROOM TEMP
ROOM TEMP SET
ROOM TEMP SET
ON
SET
OFF
WALL
ROOM
TEMP
ON
OFF
SET
ECS