Elitegroup TRW-1 - Manual (Page 9)

REV.1/25/05 Page 9 of 9 Part #17810
REMOTE WALL THERMOSTAT RECEIVER
INSTALLATION INSTRUCTIONS
16660
EFFECTIVE DATE JUNE 2004
Remote Wall Thermostat Receiver - Cast Iron Series
Use the following steps to attach the remote receiver to the cast iron stoves:
1. Attach, from left to right, the slide-on cover plate onto the remote receiver. ON will be to the top and OFF will be to the bottom on the
slide-on cover plate.
2. Push the receiver slide button onto the receiver slide switch. Reverse installation of the slide button if it is off center.
3. Attach velcro loop on the left side of the valve cover support.
4. Attach velcro hook onto remote receiver. The word TOP on the remote receiver should be to the top when installed onto valve cover
support.
5. Attach velcro hook on remote receiver onto velcro loop on valve cover support.
Remote Wall Thermostat Receiver - Direct Vent Fireplaces and Vent-Free Fireplaces
Use the following steps to place the remote receiver in the bottom of the inner casing assembly, adjacent to the gas valve.
1. The remote receiver can not be placed behind the gas valve.
2. When facing the appliance, the remote receiver must be placed to the right of the gas valve.
Remote Wall Thermostat Receiver - Vent-Free Log Sets (Millivolt System)
Use the following steps to place the remote receiver adjacent to the gas valve.
1. The remote receiver can not be placed behind the gas valve and burner assembly.
2. When facing the appliance, the remote receiver can be placed to the right of the gas valve and burner assembly or under burner
pan left of gas valve.
Remote Wall Thermostat Receiver - DV-210 and DV-215
Attention: Do not install remote receiver inside furnace.
Use the following steps to attach remote receiver.
1. Attach remote receiver at bottom of either side on outer casing.
2. If furnace is installed high enough above floor, attach remote receiver on the underside of furnace.
Remote Wall Thermostat Receiver - DV-25 and DV-35
Attention: Do not install remote receiver inside furnace.
Use the following step to attach remote receiver.
1. Attach remote receiver to the underside of the furnace, adjacent to the right of piezo ignitor.
Remote Wall Thermostat Receiver - DVC-35, DV-55, FAW-40 and FAW-55
Use the following step to attach remote receiver.
1. Attach remote receiver in the interior, bottom of furnace, adjacent to gas valve.
Remote Wall Thermostat Receiver - GWT-25, GWT-35 and GWT-50
Use the following step to attach remote receiver.
1. Attach remote receiver to wall sill or floor plate.
Remote Wall Thermostat Receiver - DV-20E, DV-40E and DV-55E
Use the following step to attach remote receiver.
1. Attach remote receiver in the interior of the furnace, adjacent to the right of pressure switch.
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
Attention: Velcro loop and hook are not necessary for all installations.