Silvercrest Z30258-BS - Manual (Page 37)

37 GB/MT
Safety Information / Before Initial Use / Operation

Remove spent batteries from the product
immediately. Otherwise there is an increased
risk of leakage.

Always replace all batteries at the same time
and only use batteries of the same type.

Do not use different types of batteries or mix
used and new batteries together.

Check regularly that the batteries are not leaking.

Leaked or damaged batteries can cause chemical
burns if they come into contact with the skin; in
such cases you must wear suitable protective
gloves.

Remove the batteries from the product if it is
not in use for any length of time.

Ensure the correct polarity when inserting the
batteries! Otherwise the batteries may explode.
The direction in which the batteries should face
is indicated in the battery compartment.

Never attempt to recharge batteries which are
not rechargeable.
 Before Initial Use
Note: You can operate the roll piano by means of
the mains adapter or with batteries.
 Operating the roll piano by
means of the mains adapter

Insert the plug of the mains adapter into the
socket on the back of the control unit.

Insert the plug of the mains adapter into a cor-
rectly installed power socket.
 Inserting / Replacing
the Batteries

Open the battery compartment on the back of
the control unit.

Remove any used batteries.

Insert 4 batteries (1.5 V , AA) into the battery
compartment.
Note: Ensure the correct polarity. This is shown
in the battery compartment.

Close the battery compartment by means of
the battery compartment cover.
 Operation
 Turning the Roll Piano on / off

Press the ON / OFF button to turn the roll piano
on or off.
Note: When the product is switched on, the
POWER LED lamp lights up in red.

Press the buttons to use the roll piano.
 Making Adjustments
Adjusting the Tone:
Note: The RHYTHM LED does not light up during
the adjustment process.
1. Press TONE on the Select button RHYTHM / TONE.
2. Press one of the Number buttons
RHYTHM / TONE to select the desired tone
(see “Functions” > “Tones”).
3. Press TONE again on the Select button RHYTHM /
TONE to confirm your input. A sample tone
sounds as a confirmation of the selected tone.
OR
1. Press TONE on the Select button RHYTHM / TONE.
2. Then press + or – on the Selection button
RHYTHM / TONE to call up the next tone from
the list in turn (see “Functions” > “Tones”).
3. Press TONE again on the Selection button
RHYTHM / TONE to confirm your input. A sample
tone sounds as a confirmation of the selected tone.
Setting the Rhythm:
Note: The RHYTHM-LED lights up in green during
the adjustment process.
1. Press RHYTHM on the Select button
RHYTHM / TONE.
2. Press one of the Number buttons
RHYTHM / TONE to select the desired rhythm
(see “Functions” > “Rhythms”).