Silvercrest SMK 15 A1 - Manual (Page 7)

SMK 15 A1 5
4. Operating the Appliance
4.1 Using the appliance for the first
time
1. For reasons of hygiene, clean the
appliance thoroughly inside and out
before using it for the first time or if it
has not been used for a long time (see
“5.1
Cleaning the appliance” on
page 6).
2. Select a location that is well ventilated
and protected from heat and sunlight.
3. Place the appliance on a level, non-slip
surface.
4. Turn the function selector 6 and the
voltage selector 7 to the OFF position.
4.2 Selecting a voltage
Use the voltage selector 7 to select the
required voltage:
12V: operating on a car electrical
system
230V: operating on the mains
OFF : appliance is switched off.
4.3 Connecting the appliance to the car
electrical system
Note: When operated on a vehicle 12 V
system the cooling and warming
performance is not quite so high as when
operated on 230 V mains (see “7. Technical
Data” on page 8).
1. Plug the car lead
11 into the socket 8 .
2. Connect the car lead 11 to the car elec-
trical system, e.g. the cigarette lighter.
Note: You may need to pull the red cap
off the car plug.
4.4 Connecting the appliance to the
mains
1. Plug the mains lead 3 into the socket 9 .
2. Connect the mains lead 3 with the mains
supply.
4.5 Selecting a function
Use the function selector 6 to select the
required function:
OFF: appliance is switched off.
WARM: appliance warms and the red
indicator 10 lights up.
COOL: appliance cools and the green
indicator 5 lights up.
4.6 Select operating temperature
Set the operating temperature on tempera-
ture selector
4 . Set temperature selector 4 to
for minimum output. Refrigeration per-
formance can be increased, if required, by
turning temperature selector
4 towards
(maximum output). However, this will
increase energy consumption. To save
energy, output can be reduced again by
turning temperature selector
4 back towards
(minimum output).
4.7 Emptying the drip tray
Condensation water may collect in the drip
tray
12 . Depending on the duration and
intensity of operation, the drip tray 12
should be checked regularly and emptied if
necessary:
1. Pull the drip tray
12 forwards and out.
2. Empty out any condensation water
present.
RP71570 MiniCool LB4 Seite 5 Dienstag, 6. Dezember 2011 10:18 10