Enterasys Networks SecureStack C2RPS-CHAS2 - Manual (Page 28)

Connecting the PSM Cables and AC Power Cords
2-6 Installation
Connecting the PSM Cables and AC Power Cords
The PSMs are connected to the SecureStack C2 Ethernet switch devices using C2RPS‐PSM
Cables.
To connect the PSMs, proceed as follows:
1. Connect one end of the C2RPS‐PSM Cable (shown in Figure 2‐3 ) to the Redundant
Power Supply connector on the switch device. Then connect the other end to the
Redundant Power Supply connector at the rear of the PSM as shown in
Figure 2‐4 and
Figure 2‐5 .
2. Connect a standard AC power cord to the AC input power connector on the PSM
shown in
Figure 2‐4 , then plug the AC power cord into the main AC power outlet.
3. The green Power LED on the front of the PSM will illuminate to indicate a successful
connection. If the LED remains off, proceed as follows:
a. Check the AC power cord connection at the AC power source and make sure the
power source is within specification.
b. Check the AC power connection to the PSM.
c. Swap the AC power cord with a known good one.
d. If the green LED continues to remain off, contact Enterasys Networks. Refer to
“ Getting Help ” on page 1‐5 for instructions. Otherwise, proceed to step 4.
4. If installing two PSM power supplies, repeat steps 1 through 3 for the second PSM.
Figure 2-3 C2RPS-PSM Cable
Figure 2-4 Power Connectors on C2RPS-PSM (rear view)
1 Redundant Power Supply connector 2 AC power connector (rear of chassis)
AC LINE
100-240 VAC
50-60 Hz
2A MAX
Redundant Power Supply
А Б