Silvercrest Z29777A / Z29777B - Manual (Page 19)

19 GB/MT
Do not place the scales on a carpet, otherwise
this may influence the results. If necessary you
can place a board on the carpet and place the
scales upon this. A solid floor covering is required
in order to achieve correct weight measurements.
Switch on the scales by stepping onto it.
Note: First four eights appear briefly, as shown
in Fig. A. This activates the vibration sensor in
the scales. The scales are ready to measure
your weight.
Place even weight on each leg.
If at all possible stand on the same areas of the
platform 2 each time and do not move.
Moving during the weighing process can lead
to discrepancies in the results.
The scales will start to measure immediately. After
blinking three times, the weight display will dis-
play the result, as shown in, for example, Fig. C.
Note: It shows “0.0” (see fig. B), if user steps
down before blinking three times.
Note: If the scales show “Err” (see Fig. F), it sig-
nals that the scales are overloaded. Observe the
maximum capacity of 180 kg (400 lbs / 28 st).
Step off the platform 2 . The scales switch off
automatically after about 15 seconds.
Until then the weight measurement remains visible.
Troubleshooting
- This appliance has delicate electronic components.
This means that if it is placed near an object that
transmits radio signals, it could cause interference.
This could be, for example, mobile telephones,
walkie talkies, CB radios, remote controls and
microwaves. If the display indicates a problem,
move such objects away from it.
- Electrostatic charge can lead to the appliance
failing. In cases of the appliance failing to work
remove the batteries for a short while and then
replace them.
Cleaning
Do not use chemical cleaners or scouring
agents for cleaning the device.
Clean the device using a slightly moist cloth.
For more stubborn dirt you can also apply a
weak soap solution to the cloth.
Never immerse the device in water or other liquids.
Ignoring this advice may damage the device.
Ensure that no water enters the device. If this
does occur, then wait until the device has dried
out fully before you use it again.
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
hours can be obtained from your local
authority.
Faulty or used batteries must be recycled in accord-
ance with Directive 2006 / 66 / EC. Please return
the batteries and / or the device to the available
collection points.
Pb
Environmental damage
through incorrect disposal
of the batteries!
Batteries must not be disposed off with domestic
waste. They may contain toxic heavy metals and
are subject to hazardous waste treatment rules and
regulations. The chemical symbols of the heavy
metals are as follows: Cd = cadmium, Hg = mercury,
Pb = lead. That is why you should dispose of used
batteries at a local collection point.
EMC