Silvercrest SRW 250 A2 - Manual (Page 74)

SRW 250 A2 Alarm Clock Radio
72 - English
When powering the device on for the first time, the
device goes into clock setting mode automatically and
the hour display flashes[10]. Upon factory delivery the
time format is set to 24-hours.
 Press the – [7] or + [8] button to set the hour. You can also press and
hold the – [7] or + [8] button.
 Then press the TIME/DIMMER button [1] quickly to set the minutes.
The minutes counter flashes on the display [10].
 Press the – [7] or + [8] button to set the minutes. You can also press
and hold the – [7] or + [8] button to set the minutes in 10-minute
steps.
 Press the TIME/DIMMER button [1] to toggle between 12 and 24
hour mode. “24” or “12” is shown on the display [10].
 You can then the – [7] or + [8] button to change between 12 and
24-hour time mode. To distinguish between morning and afternoon
time in 12-hour mode, there is a PM LED [18] on the display.
 Wait until the display [10] shows the set time or press the
TIME/DIMMER button [1] briefly.
Please note that you can only set the time while the
display is flashing [10]. If no input is made for a few
seconds, the display [10] stops flashing and the
procedure needs to be repeated.