Silvercrest SRW 250 A2 - Manual (Page 78)

SRW 250 A2 Alarm Clock Radio
76 - English
Please note that you can only set the alarm time and
alarm volume while the numbers are flashing on the
display [10]. If no input is made for a few seconds, the
numbers on the display [10] stop flashing and you will
have to repeat the procedure.
Enabling the Alarm
After the you have set the alarm time you want, you can enable the alarm
as follows:
 Press the ALARM1 [3] or the ALARM2 [5] button quickly. The AL1
alarm sound LED [23] or the AL2 alarm sound LED [20] lights up on
the display [10]. The alarm is now enabled for the set time and with
the alarm sound.
 Press the ALARM1 [3] or the ALARM2 [5] button again quickly. The
AL1 alarm radio LED [22] or the AL2 radio [21] lights up on the
display [10]. The alarm is now enabled for the set time and with the
radio.
 To disable the alarm, press the ALARM1 [3] or the ALARM2 [5]
button again. While the alarm is disabled, the AL1 alarm sound LED
[23], the AL1 radio LED [22], the AL2 alarm sound LED [20] and the
AL2 radio LED [21] are off.
In radio alarm mode, the device powers on at the alarm time
set and receives the last frequency and the last volume set. In
buzzer alarm mode the alarm will sound with the volume
assigned to the corresponding alarm function too.