Silvercrest SHBS 1000 A1 - Manual (Page 69)

66 SHBS 1000 B1
GB
Trimming without add-ons
WARNING
► The trimmer block is very sharp. There is a risk of personal injury!
You can cut your hair to lengths between 0.5 mm and 2.5 mm without using a
cut length add-on
7 . Move the slide switch 2 to the required length to fi ne-
adjust the cutting length.
NOTE
► Depending on how you hold your hair and beard trimmer and the resulting
angle, the cut length can vary from the lengths stated in this operating
manual and marked on the add-on/appliance.
Thinning your hair
You can use this function to reduce the volume of your hair because only part
of the hair is gripped and trimmed.
♦ To thin your hair, clip the thinner add-on 8 onto the trimmer block from the
front until it engages. When doing so, the thinner add-on 8 must protrude past
the trimmer head teeth.
Cutting the edges of the hairline, neck and sideburns
♦ Turn the appliance round so that the rear side is facing upwards.
♦ Place the edge of the trimmer block without a cut length add-on 7 at the
required height along the hairline.
♦ Switch the hair and beard trimmer on and move it downwards.
Trimming and cutting your beard
♦ Select a cut length add-on depending on the required beard length.
♦ Now trim your beard in stages.
IB_31711_SHBS1000B1_LB1.indb 66 IB_31711_SHBS1000B1_LB1.indb 66 03.02.14 08:10 03.02.14 08:10