Silvercrest SHBS 1000 A1 - Manual (Page 70)

67 SHBS 1000 B1
GB
Cleaning and care
DANGER
Danger to life due to electric shock!
► Pull the power supply unit 6 out of the power socket before cleaning the
appliance.
► Never touch the power supply unit 6 with wet hands, especially when
plugging it in or unplugging it.
► Always keep the power supply unit 6 and the cable dry.
CAUTION
Possible damage to the appliance.
► The hair and beard trimmer may never be immersed in water or other fl uids
for cleaning, since the appliance is not watertight. If this is done, live parts
(batteries) can be damaged.
► Do not use aggressive or abrasive cleaning agents, as these can damage
the upper surfaces.
► Clean the housing exclusively with a soft damp cloth and a mild dishwashing
liquid.
♦ Switch the hair and beard trimmer off by pressing the ON - OFF switch 3 .
♦ Disconnect the cable from the appliance and pull the power supply unit 6 out
of the power socket.
♦ Take the cut length add-on 7 off the appliance.
♦ If necessary, you can wash the cut length add-ons 7 under running water.
♦ Always dry the cut length add-ons 7 thoroughly afterwards.
♦ To remove the trimmer block from its holder (see Fig. D), press your thumbs
against the shaving head teeth from the front.
♦ Use the cleaning brush supplied to remove any residual hair from the trimmer
block
.
♦ Once you have completed cleaning, plug the trimmer block plug-in tab back
into the mounting opening in the shaving head holder (see Fig. E).
♦ Allow the trimmer block to engage again by pressing lightly from behind
(see Fig. F).
NOTE
► In order to reduce friction, occasionally apply a couple of drops of scissor
oil (accessory) between the blades, and then distribute it evenly. You can
also use any acid-free oil (e.g. sewing machine oil). Wipe any access oil
off with a cloth.
IB_31711_SHBS1000B1_LB1.indb 67 IB_31711_SHBS1000B1_LB1.indb 67 03.02.14 08:10 03.02.14 08:10