Silvercrest SFR 1200 A1 - Manual (Page 53)

51 GB
To maintain a designer stubble look, shave
dry with an attached protective lid regularly.
In this case, the protective lid acts as a de-
signer stubble attachment.
• Shave your face as described in the
chapter "Dry shaving (Rechargeable
battery and mains operation)".
7. Cleaning and
maintenance of the
device
DANGER! Risk of electric
shock!
• The shaving head4 can be cleaned un-
der running water. Disconnect the de-
vice from the plug-in power unit
cable14 prior to doing so.
• The plug-in power unit and the corre-
sponding cable14 must not be held un-
der running water and must not be
immersed in other liquids.
WARNING! Risk of material dam-
age!
• Do not use any astringent or abrasive
cleaning agents.
• Do not place excessive pressure on the
shaving foils1. They are thin and can
be damaged easily.
• Use the cleaning brush15 for cleaning
the cutter block only. Under no circum-
stances should the shaving foils1 be
cleaned with it.
NOTE: to ensure a consistently smooth
shave, the device must be cleaned and
maintained regularly.
Cleaning after every dry shave
1. Press both release buttons3 and take
off the shaving foil frame2.
2. Tap the shaving foil frame2 carefully.
3. Clean the cutter blocks13 with the
cleaning brush15.
4. Place the shaving foil frame2 on the
device in such a way that it locks into
place.
Cleaning after every wet shave/
occasionally after dry shave
1. If necessary, wipe the device (not the
shaving foils1) with a slightly mois-
tened cloth.
2. Press the release button10. The shav-
ing head4 opens up.
3. Hold the device facing down and rinse
the cutter block and the shaving foil
frame2 in the shaving head4 under
running water.
4. Allow the parts to dry completely.
• Depending on the intensity of usage,
but at least every 6 months, carefully
spread a small amount of sewing ma-
chine oil on the shaving foils1, the cut-
ter blocks13 and the long hair
trimmer12.
8. Storage
DANGER! Keep the device out of
the reach of children.
• When the device is not being used,
place the protective lid11 on the shav-
ing head4.
• The device and accessories can be
stored in the storage pouch16.
__GRA90253_B5.book Seite 51 Dienstag, 23. April 2013 2:18 14