Silvercrest SSR 1080 B2 - Manual (Page 83)

Satellite Receiver SSR 1080 B2
81 - English
Channel List
Next select a preset channel list or select “Auto Search” or
“Manual Search” to launch a channel search.
We recommend you choose a preset channel list or use the “Auto
Search” function. Press the OK/ENTER button (25) or the [Blue]
button (22) to continue to the next step.
If you have selected a preset channel list, you can start using your
satellite receiver now. If you have chosen “Auto Search”, please
proceed as follows:
Select the satellite that you want to scan for channels from the list
and press the OK/ENTER button (25). A new window opens on the
right hand side of the screen. The following options are greyed out
and cannot be edited: “LNB Power”, “LNB Frequency” and
“0/22KHz”.
DiSEqC Switch
To successfully launch a channel search, you need to adjust your
satellite receiver to the antenna installed. If you want to receive only
one satellite, select “No”. If you want to receive more than one
satellite, please read the chapter on “Installation” starting from
page 85.
DiSEqC Port
If you have selected the option “No” for the “DiSEqC Switch”
setting above, this is automatically set to “No”.
Signal Level Indicators
The signal strength (S) and the signal quality (Q) are displayed on
the right. Point your antenna so that the signal strength and signal
quality reach their maximum.
Press the [Blue] button (22) to continue to the next step.
Search Option
Search Range
Select the channels you wish to search for.
All Channel
The device will search for all channels (unscrambled, scrambled,
radio and TV channels).
Free Channel
The device will search for unscrambled channels only.
Scrambled Channel
The device will search for scrambled channels only.
TV Only
The device will search for TV channels only.
Network Search
Some satellites support what is known as a network search. They
broadcast a table (NIT = Network Information Table) containing all
available channels. This allows the satellite receiver to obtain
information about all channels.
You can choose whether to perform a network search or not here.
Press the [Blue] button (22) to launch the channel search.