Silvercrest SWED 100 A1 - Manual (Page 86)

SilverCrest SWED 100 A1
84 - English
SLEEP timer
With the SLEEP timer, you can set a time between 10 and 90 minutes after
which your world receiver (A) automatically switches off. The setting is
made in intervals of 10 minutes. Proceed as follows:
 Switch off the device with the "POWER" button (6).
 Press the "POWER" button (6) for approximately one second until a
beep sounds and the number 90 (for 90 minutes) is indicated on the
display (5).
 Then press the "POWER" button (6) repeatedly until you reach the
desired number of minutes (for example, 40). Each time you press the
"POWER" button (6), the number of minutes to switching off is reduced
by 10 minutes.
 The world receiver (A) then switches itself on and, after the previously
selected minutes (for example, 40), it switches itself off automatically.
 The display (5) indicates "SLEEP" (25) when the SLEEP timer is activated.
 You can change the frequency band, start the station scan, access
saved stations and adjust the volume even when the SLEEP timer is
activated.
 You can delete the activated SLEEP timer by switching off the device.
Setting the alarm time
You can set one alarm time. Make sure that the time is set correctly. You
can set the alarm time only when the device is switched off. Switch off the
device with the "POWER" button (6) if it is switched on.
 Briefly press the "ALARM" button (10). The "ALARM" symbol (27) and
the current alarm time are then indicated on the display (5).