Silvercrest SPW 180 B2 - Manual (Page 36)

SilverCrest SPW 180 B2
34 - English
First use
Switching on the scales / measuring weight
Due to the step on power function, the glass scales are switched on automatically when you step
on the tread (2) and they start to measure your weight immediately.
In their original state, the glass scales are set to the "kg" unit of weight. To change the unit of
weight, press the "Button for setting the unit of weight" (3) when the scales are switched on. The
selected unit of weight is then indicated on the LCD display (1).
Stand on the tread (2) of the scales so that your weight is evenly distributed. Remain as still as
possible during the weighing process as the measurement result may be distorted otherwise. The
measurement result is indicated on the LCD display (1) during the weighing process. The
measurement is complete when the display flashes three times.
Solid ground is required to measure weight correctly. Thus always place the
glass scales on a solid, horizontal floor covering and never on carpet. This can
distort the measurement result.
To obtain comparable measurement results, you should always weigh yourself
if possible at the same time of day (preferably in the morning). Always weigh
yourself if possible under the same conditions: on an empty stomach, after
having gone to the toilet and naked.
Please note that values for the stone unit of weight are not represented as
decimal values. The display is divided into two segments by a colon. Only
whole numbers are displayed in the "st" unit of weight to the left of the colon.
The remaining weight is displayed in the "lb" unit of weight to the right of the
colon.
Example: "6:6.8 st" is shown on the display. This corresponds to 6 st and
6.8 lb.
Auto Power Off
The glass scales have an automatic switch-off function (Auto Power Off function). The glass scales
switch off automatically about 10 seconds after you step off the tread (2).