Silvercrest SPW 180 B2 - Manual (Page 37)

SilverCrest SPW 180 B2
English - 35
Troubleshooting
Nothing is indicated on the LCD display

The lithium battery CR2032 is empty. Replace the lithium battery CR2032 with another of the
same type. In this case, please observe the instructions for inserting the battery on page 33.

The lithium battery CR2032 is inserted incorrectly. In this case, please observe the instructions
for inserting the battery on page 33.
"Lo" is indicated on the LCD display and the scales switch off

The lithium battery CR2032 is almost empty. Replace the lithium battery CR2032 with
another of the same type. In this case, please observe the instructions for inserting the battery
on page 33.
"USEL" is indicated on the LCD display and the scales switch off

An error has occurred and the scales cannot measure your weight. In this case, step off the
tread (2) of the scales and step on it again. The weight measurement starts again.
"Err" is indicated on the LCD display

Your weight exceeds the maximum load capacity of 180kg / 396lb / 28st. You should step
off the tread (2) of the glass scales immediately to avoid damaging the scales.
Cleaning / maintenance
It is necessary to service the glass scales if they have been damaged in any way, for example, if the
housing is damaged, if liquid or objects have penetrated the scales or if they have been exposed to
rain or moisture. Servicing is also required if the scales are not working properly or have been
dropped. If smoke is produced, or there are any unusual sounds or smells, remove the battery
immediately from the glass scales. In such cases, the scales should not be used until they have been
inspected by authorised service personnel. Only have qualified personnel carry out the
maintenance work on the device. Never open the housing of the glass scales. Only use a clean, dry
cloth for cleaning and never use any corrosive liquids.