Silvercrest SWR 300 A1 - Manual (Page 78)

SilverCrest SWR 300 A1
76 - English
Troubleshooting
The Power LED (1) does not light up.
 Socket defective or fuse tripped; check the socket with another device.
The configuration menu of the wireless repeater is not shown.
 The IP address http://192.168.10.1 was entered into the address line of the Internet browser
incorrectly; check and correct the entry.
 The wireless repeater has already been configured and is using another IP address. To be able to
establish a connection to the wireless repeater, the IP address of your computer must be
changed. Proceed as follows:
 Turn on your computer.

Click on Start | Control Panel | View network status and tasks | LAN
connection | Properties | Internet Protocol Version 4 (TCP/IPv4) | Properties.
 Now select Use the following IP
address and enter an IP address
between 192.168.10.100 and
192.168.10.200 (for example,
192.168.10.101). Now enter the IP
address 255.255.255.0 under
Subnet Mask and click on OK.
 Then close all opened windows.
 The wireless repeater has already been configured and is using another IP address. Reset the
wireless repeater to the factory default settings. Hold down the reset button (7) for at least 10
seconds until the LEDs briefly go out and then come on again.