Silvercrest SHTR 2200 A1 - Manual (Page 6)

3 SHTR 2200 A1
GB
Safety instructions
RISK OF ELECTRIC SHOCK
► Connect the hair dryer only to a correctly installed mains power socket
providing electrical energy at the level detailed on the rating plate.
► Under no circumstances may the hair dryer be submerged in fl uids, or
fl uids be permitted to enter the appliance housing. Do not expose the
appliance to humidity and do not use it outdoors. Should liquids enter the
housing, disconnect the appliance from the power source immediately and
arrange for it to be repaired by a qualifi ed technician.
► Disconnect the hair dryer from the mains power socket if defective opera-
tion is apparent and before cleaning it.
► To disconnect it, pull only on the plug itself, not on the power cable.
► Do not wrap the power cable around the appliance and protect the cable
from being damaged.
► Should the power cable of the appliance be damaged, to avoid potential
risks it must be replaced by the manufacturer, his customer service or by a
qualifi ed technician.
► Do not kink or crush the power cable and lay it in such a way as to prevent
people from stepping on or tripping over it.
► Do not use extension cables.
► Never touch the hair dryer, the power cable or the plug with wet hands.
► Disconnect the hair dryer from the power source immediately after use. The
appliance is completely free of electrical power only when you unplug it.
► You are not permitted to open or repair the housing of the hair dryer. Should
you do so, appliance safety can no longer be assured and the warranty
will become void. Arrange for the hair dryer to be serviced and repaired
only by qualifi ed specialists.
Never use the appliance near water, particularly not near sinks, baths
or other vessels. The proximity of water presents a risk, even when the
appliance is switched off . After use, always disconnect the plug from the
mains power socket. As additional protection, the installation of a faulty-
current protection unit with an activation power rating of not more than
30 mA is recommended for the power circuit in the bathroom. Consult
your electrician for advice.
IB_73368_SHTR2200A1_LB4.indb Abs2:3 IB_73368_SHTR2200A1_LB4.indb Abs2:3 01.08.12 15:19 01.08.12 15:19