Silvercrest SWK 2200 B2 - Manual (Page 11)

8 SWK 2200 B2
GB
NOTE
► If you wish to stop or interrupt the boiling procedure, simply move the
On/Off switch 4 back to the " " position. You can continue the boiling
process, but you must wait for 20 seconds until the heating element has
cooled down. You can then switch the appliance back on.
CAUTION - PROPERTY DAMAGE!
► Do not press the On/Off switch 4 during the cooling phase, since this
could result in damage to the appliance.
7) Disconnect the appliance from the mains power socket when not is not in
use, in order to prevent an unintentional activation.
WARNING - RISK OF INJURY!
► For safety reasons you should not open the lid when the water is boiling or
extremely hot. Risk of scalding.
TIPS
► This appliance is equipped with an overheating protection: if the appliance is
switched on unintentionally without any water in the kettle 8, the appliance
switches itself off automatically.
If the appliance boils dry because the lid has not been closed, for example,
the appliance switches itself off automatically.
In these cases, allow the appliance to cool down before using it again.
IB_111451_SWK2200B2_LB4.indb 8 06.01.15 09:23