Silvercrest SMB 70 A1 - Manual (Page 30)

27 SMB 70 A1
GB
WARNING! RISK OF INJURY!
► This device is not intended for use by persons
(including children) with limited physical,
physiological or intellectual abilities or lack
of experience and/or knowledge unless they
are supervised by a person who is responsi-
ble for their safety, or receive instructions from
this person on how to use the appliance.
► Children should be supervised to ensure that
they do not play with the appliance.
► To ensure that you can disconnect the appli-
ance quickly in the event of an emergency,
do not use extension cables.
ATTENTION! DAMAGE TO PROPERTY!
► Do not place vases or other containers fi lled
with liquid on the appliance!
► Ensure that the ventilation slits are not covered
when the appliance is in use. Risk of over-
heating! Maintain a clear distance of at least
15 cm between the ventilation slits and other
objects.
► Do not operate the appliance in rooms with
high humidity (bathrooms etc.) or rooms
in which explosives or easily infl ammable
materials or gases are stored. Rooms which
may have poor air circulation, e.g. garages,
are also unsuitable.
► Do not transport the minibar unless it is
empty. Remove all bottles before the trans-
portation.
► Do not place the appliance close to open
fl ames or other sources of heat (heating,
direct sunlight, gas stoves, etc.).
► Never place the appliance in a fi tted cup-
board, recess or the like.
Before fi rst use
Placement of the bottle racks
NOTE
► In order to insert or remove the bottle racks, the
door 7 of the appliance must be opened by
90°. This provides maximum room for remov-
ing or inserting the bottle racks q/w.
■ Slide the bottle racks w into the rails:
Ensure that the recesses for the bottles point
downwards.
Ensure that the small locking brackets at the
bottle racks w are in the recesses at the rear
end of the rails.
■ Slide the double bottle rack q into the lower rail.
Setting up
ATTENTION! DAMAGE TO PROPERTY!
► Ensure that the ventilation slits and the fan
are not covered when the appliance is in
use. Risk of overheating! Maintain a clear
distance of at least 15 cm between the venti-
lation slits and other objects.
■ Place the appliance on a clean and level
surface.
■ If the appliance is slightly unstable, the uneven-
ness of the surface upon which it has been
placed can be compensated for using the
adjustable feet 0. To do this, turn the relevant
adjustable feet 0 until the appliance is stable.