Silvercrest SPU 900 A2 - Manual (Page 63)

- 60 -
do, it may overheat and become irrepa-
rably damaged.
• Never cover the ventilation slots of the
appliance while it is switched on.
• Do not place open fire sources, such
as candles, on or near the appliance.
Caution with thunderstorms!
• Equipment connected to a power supply
can be damaged during a thunderstorm.
You should therefore always pull the
power plug from the power socket when
there is a storm.
Warnings about interaction with
batteries
The appliance uses batteries for memory
storage. When handling batteries,
please observe the following:
• If you do not intend to use the appliance
for an extended period, remove the
batteries.
• Regularly check the condition of the bat-
teries. Leaking batteries can cause dam-
age to the appliance.
• Should the batteries leak, put on a pair
of protective gloves and clean the bat-
tery compartment and terminals with
a dry cloth.
Caution!
Never subject the batteries to excessive heat
(i.e. bright sunlight, fire, etc.).
Attention!
There is a risk of explosion if the batteries are
improperly replaced. Only replace with the
same or equivalent types.
Notice regarding separation
from mains-power
The button on this appliance does not
completely disconnect it from the mains
power network. Additionally, the appli-
ance consumes power when in standby-
mode. To completely separate the appli-
ance from mains power, the plug MUST
be removed from the wall socket.
Notice regarding electrical
power surges (EFT / electrical
fast transient) and electrostatic
discharges:
In a case of malfunction due to an elec-
trical fast transient (power surge) and/
or electrostatic discharge, the appliance
must be returned to default settings in
order to re-establish normal operation.
This could mean that it must be discon-
nected from the power supply and then
reconnected. The batteries (if present)
must be removed and then reinserted.
Notice
No liability/warranty claims will be con-
sidered for damage to the appliance
caused by the effects of moisture, water
penetration, overheating or due to un-
authorised modifications!
BDA_SPU 900 A2 - IAN-90514_1_en.indd 60 22.07.2013 13:42:56