Silvercrest SPU 900 A2 - Manual (Page 67)

- 64 -
4. Press the buttons DOWN/UP i/o to set
a different time.
Press the MODE/LOCK button e once
again to close adjustment.
Timer function
1. Press the NAP/USER k button. The NAP
display appears in display g and the
minute display 10 flashes.
2. Use the DOWN/UP i/o button to set
the required number of minutes (1 to 120
min.).
3. Press the button NAP/USER k once
again to start the Timer. In the display g
the remaining time is indicated.
4. Should the time be expired, the timer
signal will sound for about 10 minutes,
the NAP indicator flashes and the time is
displayed.
5. Press any button to end the alarm.
6. If you wish to end the Timer function
before the alarm, press and hold the
button NAP/USER k for one second.
Alarm function (Alarm 1 to 4)
You can programme in up to four alarm
times on your radio alarm. If a button is not
pressed within approx. 15 seconds, the ap-
pliance saves the adjustment and then leaves
the programming mode.
1. With the radio switched off, press the
AL.SET button a to call up the alarm
function. Using the PRESET/ALARM +/–
buttons s/d, select the desired alarm
memory position. In the display g the last
set alarm time and the symbol for the type
of alarm (radio or signal tone) blinks.
2. Press the buttons DOWN/UP i/o to set
the desired alarm time. Pressing and hold-
ing down one of the buttons DOWN/UP
i
/o changes the alarm time in quick suc-
cession.
3. Press the button AL.SET a until the desired
alarm function (see table) is indicated in
the display g.
Alarm function Symbol in the
display g
Acoustic signal
Radio
Switched off no symbol
4. Press the button SNOOZE/DIMMER y
to set the weekdays on which you require
the alarm function: You can choose be-
tween “workdays” (MON, TUE, WED,
THU, FRI), “weekends” (SAT, SUN) and
“every day” (MON, TUE, WED, THU,
FRI, SAT, SUN).
5. Hold the button SNOOZE/DIMMER y
pressed down for 2 seconds when you
want to be woken on a specific weekday.
To programme this weekday, repeatedly
press the SNOOZE/DIMMER button y.
Orientate yourself on the weekday indica-
tor at the top right in the display:
MON: = Monday
TUE = Tuesday
WED = Wednesday
THU = Thursday
FRI = Friday
SAT = Saturday
SUN = Sunday
6. To return to the selection of workdays,
weekends or whole weeks, once again
hold the SNOOZE/DIMMER button y
pressed down for 2 seconds.
7. After approx. 15 seconds the display g
returns to time indication. The adjustment
for the alarm function is now saved and
will be shown.
8. If needed, programme the other memory
positions for alarm times as detailed above.
9. If you wish to be woken by the radio func-
tion, switch the radio on now and select
the desired radio station. Then adjust the
sound volume to the maximum to be
achieved during the alarm procedure.
BDA_SPU 900 A2 - IAN-90514_1_en.indd 64 22.07.2013 13:42:56