Silvercrest SDRB 1000 A1 - Manual (Page 46)

- 43 -
Should the mains water at your locality be rated as
hard, it is recommended that you mix mains water
with some distilled water. Otherwise, the jets for the
steam blast function could calcify (become blocked)
prematurely.
To extend the optimal steam blast function, mix mains
water with distilled water according to the table.
The water hardness level can be queried at your
local water works.
Attention!
Before refilling with water, ALWAYS remove the po-
wer plug 7 from the mains power socket! There is
a risk of electric shock!
• Lift the watertank 1 up vertically, in that you slide
the runlocking device 4 for the watertank 1 to the
rear until the watertank 1 allows itself to be lifted
off. Grasp the watertank 1 with your thumb and in-
dex finger on the hatched markings to lift it vertically
upwards. The temperature regulator 3 remains on
the appliance and is not lifted off.
• Open the water fill opening 2 to the watertank 1.
• Using the measuring beaker t, fill the water-
tank 1 with mains water to the "Max" marking,
but no further.
Water hardness
Ratios - distilled
water to mains
water
very soft / soft 0
medium 1: 1
hard 2: 1
very hard 3: 1
• Close the water fill opening 2 to the water tank 1.
Ensure that the lug on the water fill opening 2
sits in the indentation on the lid. Only in this way
is the watertank 1 properly closed.
• Replace the watertank 1 back onto the appliance.
The watertank 1 must audibly engage with the
unlocking device for the watertank 4.
Attaching/detaching the brush
attachment
Attention!
NEVER attempt to attach or detach the brush attach-
ment w when the appliance is heated up.
Risk of Burns!
• To use the steam and brush function, place the
brush attachment w onto the steam brush.
• To do this, slide the brush attachment w all the
way along the guide to the end. The unlocking
device of the brush attachment q must engage
audibly.
• To be able to use the ironing function, remove
the brush attachment w from the steam brush.
• To do this, press the unlocking device q down-
wards and, at the same time, pull the brush attach-
ment w away to the front.
Steam brush function
• Place the brush attachment w onto the applian-
ce. This must engage audibly with the unlocking
device on the brush attachment q.
• Insert the power plug 7 into a correctly installed
and earthed mains power socket.
• To generate steam, set the temperature regulator 3
to at least ••• or higher. The heating-up control
lamp 5 glows. As soon as the set temperature has
been reached, the heating-up control lamp 5
goes out.
IB_93147_SDRB1000A1_CH.qxd 07.08.2013 11:15 Uhr Seite 43