Silvercrest SSM 300 A1 - Manual (Page 32)

30 GB
Instructions for safe operation
• This device must not be used by children.
• Children should not be allowed to play with the device.
• The device and the power cable must be kept away from children.
• This device can be used by people with restricted physical, sensory
or intellectual abilities or people without adequate experience
and/or understanding if they are supervised or instructed on how
to use this device safely and if they are aware of the resulting risks.
• Disconnect the mains plug from the wall socket…
… when it is not supervised,
… before you assemble or disassemble the device, and
… before you clean the device.
• Clean the blender 5 manually in washing-up water, rinse with clear
water and allow it to dry completely before putting it away.
DANGER for children
• Packing materials are not children's
toys. Children should not be allowed to
play with the plastic bags. There is a
risk of suffocation.
• Keep the device out of the reach of chil-
dren.
DANGER! Risk of electric
shock due to moisture
• This device must never be operated close
to a bathtub, shower, filled hand basin or
similar.
• The motor unit, the power cable and the
mains plug must not be immersed in wa-
ter or other liquids.
• Protect the motor unit from dampness
and dripping and splashing water.
• Should liquids enter the motor unit, pull
out the mains plug immediately. Have
the device checked before reusing.
• Never touch the device with wet hands.
• If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to retrieve the device.
DANGER! Risk of electric
shock
• Only plug the mains plug into a wall sock-
et if the motor unit has been connected to
the hand blender.
• Only connect the mains plug to a properly
installed and easily accessible wall socket
whose voltage corresponds to the specifi-
cations on the rating plate. The wall socket
must continue to be easily accessible after
the device is plugged in.
• Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around
the device.
• The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
• When using the device, ensure that the
power cable cannot be trapped or
crushed.
• To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
__RP93358_B2.book Seite 30 Dienstag, 10. Dezember 2013 11:40 11