Silvercrest SSM 300 A1 - Manual (Page 33)

31 GB
• Disconnect the mains plug from the wall
socket…
… if there is a fault,
… if you are not using the hand blender
and
… during thunderstorms.
• Do not use the device if there is visible
damage to the device or the power ca-
ble.
• To avoid any risk, do not make modifi-
cations to the device.
• If the power cord of this device is dam-
aged, it must be replaced by the manu-
facturer or the manufacturer’s customer
service, or by a similarly qualified per-
son, in order to avoid danger.
DANGER! Risk of injury
from cutting
• The blades of the blender are sharp.
Handle it with care. When washing
manually, the water should be sufficiently
clear that you can see the blades easily.
• Never reach into the rotating blades. Do
not touch rotating parts with spoons or
similar utensils. Keep long hair or loose
clothing away from rotating parts as
well.
• The blade continues to rotate after the
device is switched off. Wait until the
blade has come to a standstill before
you pull the hand blender out of the
food.
WARNING! Risk of material
damage
• The device is designed for a maximum
operating time of 1 minute without inter-
ruption. After this, the device must re-
main switched off until it has cooled
down to room temperature.
• In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the blade is either turning
with difficulty or not turning at all. Pull
out the mains plug and check whether
there is something in the vessel blocking
movement or whether the food is too
tough. Also check whether the device is
assembled correctly.
• Only use the original accessories.
• Do not use any astringent or abrasive
cleaning agents.
4. Items supplied
1 Motor unit 4
1 Blender 5
1 Set of operating instructions
5. Installation
• Remove all packing material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Clean the device prior to its first
use! (see “Cleaning” on page 32.)
DANGER! Risk of electric
shock! Only plug the mains plug 1
into the wall socket if the motor unit 4
has been connected to the blender 5.
Connecting the blender
(FigureA)
1. Place the motor unit 4 on the blender 5
in such a way, that the attachment mark-
ings
6 point to each other.
2. Turn the blender 5 in such a way, that
the attachment marking 6 on the
motor unit points to the lock mark-
ing 7. The motor unit 4 must engage
noticeably and audibly.
Removing the blender (Figure B)
• To remove, turn the blender 5 in the op-
posite direction, so that the attachment
marking points
6 to the lock marking
7 and pull the motor unit 4 off from
the blender 5.
__RP93358_B2.book Seite 31 Dienstag, 10. Dezember 2013 11:40 11