Silvercrest SNS 45 A3 - Manual (Page 122)

119 SNS 45 A3
GB
MT
TIP
► If you want to apply ornaments or small rhinestones to the nail, use the
sharp side of the Spot swirl t to place them in the non-hardened most
recent layer of the UV gel a. Then harden the UV gel a.
Apply an additional, very thin layer of UV gel a over the nail and then
harden it to ensure that the ornaments are held fi rmly in place. This gives
the ornaments better protection.
Topping up
NOTICE
► Because the natural nail grows, over time the attachment of the nail tip i
can raise itself. For this reason the gap between the cuticle and the nail
attachment must be topped up from time to time.
► A topping up is required about every 2 - 3 weeks.
Ƈ Using the sandpaper fi le u, fi le around the attachments of the hardened gel.
Ƈ Use the sanding block r until the nail is no longer shiny.
Ƈ When done, reapply UV gel a and harden it again.
NOTICE
► In this regard, see the previous chapters Application of the UV-Gel
and Hardening of the UV-Gel
IB_100059_SNS45A3_LB5.indb 119 17.06.14 16:42