Silvercrest SNS 45 A3 - Manual (Page 127)

124 SNS 45 A3
GB
MT
Malfunction causes and remedies
The following table will help with localizing and remedying minor malfunctions:
Defect Possible cause Solution
Appliance does
not switch on.
The plug is not connected.
Insert the plug into the mains
power socket.
Mains power socket does
not supply any voltage.
Check the fuses.
UV gel a does not
harden suffi ciently.
The selected treatment
time too short.
Select a longer treatment time.
One or more UV lamps
are defective.
Replace any defective UV lamps (see
chapter entitled “Exchanging UV
lamps”)
Too much UV gel a
applied.
Apply less UV gel a.
The nails were not directly
under the UV lamps. Hold the hand correctly in the
UV appliance 1.
After hardening,
a "sweat layer" re-
mains on the nails. Occurence of a "sweat-
layer" caused by polyme-
rization.
Remove the "sweat layer" with
the fi nishing solution o.
The artifi cial nails
are soft/loosened.
Loosening of the artifi cial
nails by products with a
high acetone concentra-
tion.
Apply no products with a high
acetone concentration.
The artifi cial
fi ngernails show
unevenness.
Pressure on the brush e
too high when applying
the UV gel a.
Do not press too hard on the brush e
when you are applying the UV gel a.
UV gel a unevenly applied.
Apply a further and thinner layer
of UV gel a and then harden it.
A UV lamp does
not glow.
UV lamp defect. Replace the defective UV lamp.
NOTICE
► If you cannot solve the problem with the aforementioned solutions, please
contact Customer Services.
IB_100059_SNS45A3_LB5.indb 124 17.06.14 16:42