Silvercrest SFE 1500 B2 - Manual (Page 39)

37 GB
6. Power supply
DANGER TO LIFE from
scalding!
Please ensure that children are not
able to pull the device down from the
work surface with the power ca-
ble10.
1. Before connecting the device, check that
the temperature controller6 is set to the
"0" marking.
2. Insert the mains plug into a wall socket
corresponding to the specifications of
the rating plate.
7. Using
DANGER! Risk of injury
through burning!
• Danger from explosive deflagration.
Make sure you use fat that is fresh,
clean and suitable for a fondue. Old,
used or unsuitable fat may ignite even
at low temperatures. Should the fat
catch fire while using the fondue, do not
try to extinguish it with water under any
circumstances. Smother the fire with a
saucepan lid of appropriate size or a
woollen blanket.
• The stainless steel pot2, splash guard1
and fondue forks8 become very hot
when using the fondue. Make sure you
protect your hands, e. g. with oven
gloves, and only touch the fondue
forks8 by the handles.
• Danger of burns caused by splashes of
hot liquid when dipping food into the
pot: dry food off beforehand and protect
hands and forearms with oven gloves.
• To prevent it from overflowing during
heating, the stainless steel pot2 should
not be filled above the upper marking in-
dicating the maximum filling level3.
1. Add fat, broth or cheese to the pot de-
pending on the intended use. The con-
tents must not lie above or below the two
filling level markings4 +3 in the pot.
2. Place the splash guard1 on the pot.
3. Fat and broth: turn the temperature control-
ler6 clockwise to the end stop to heat the
pot and its contents. The device will now
heat up.
Cheese: turn the temperature control-
ler6 until it is midway between the
markings "0" and MAX to melt the
cheese carefully, stirring as it melts. In-
crease or reduce the setting depending
on the way the cheese you are using
melts.
NOTE: the temperature controller6 allows
you to freely select a lower temperature after
initially heating up the pot. This is advisable,
for example, in order to keep the temperature
of the contents at just below the boiling point.
4. Prick the dried pieces of food onto the
fondue forks8 and place them in the
fat, broth or cheese.
5. Fat and broth: take the fondue forks8 out
when the food has reached the desired
consistency.
Cheese: dip the fondue forks8 into the
melted cheese, turning them as you do so
to coat the food in cheese.
6. After finishing with the fondue, turn the
temperature controller6 to "0", unplug
the device and wait until all parts have
cooled down before starting the cleaning
process.
__RP100109_B5.book Seite 37 Mittwoch, 14. Mai 2014 11:09 11