Silvercrest SBT 3.6 A1 - Manual (Page 47)

44 SBT 3.6 A1
GB
NOTE ON THE SHAVING FOIL
► If the shaving foil is damaged, do not use it any more!
― To replace the shaving foil, remove the micro shaver 3 from the hand
element q. Pull the coloured part (shaving foil holder) off the base of
the micro shaver 3.
― Use a slender object to push the shaving foil downwards on the short side
so that it is pushed out of the catch.
― Remove the defective foil.
― Push the new shaving foil carefully from below into the shaving foil holder
so that it clicks into place on the catch.
► To order replacement parts, please contact the service department (see chapter
"Warranty and service"). Please have the IAM number ready (see operating
manual cover).
Cleaning and care
RISK OF ELECTRIC SHOCK
► Before cleaning, disconnect the appliance from the mains adapter t and the
mains adapter t from the power supply.
CAUTION – PROPERTY DAMAGE!
► NEVER submerse the appliance in water or other liquids!
■ After every use, clean the attachment used with the supplied cleaning brush z to
remove loose hairs.
■ Disinfect the attachment used regularly by spraying and cleaning it with disinfectant
spray.
■ To clean the epilator head 1 thoroughly, remove it from the hand element q.
Clean the epilator head 1 under running water and then allow it to dry.
■ To clean the micro shaver 3 thoroughly, remove it from the hand element q.
Pull the coloured part from the base of the attachment and then carefully clean the
cutting blades that have now been revealed using the supplied cleaning brush z.
Then put the two parts of the micro shaver 3 back together.
■ If used regularly, the precision trimmer 6 and the micro trimmer 7 should be oiled
occasionally. Use the supplied oil i.
■ Wipe the appliance, the trimming templates o and the power adapter t with
a moist cloth. If required, use some mild detergent on the cloth. Ensure that the
appliance is completely dry before the next use.
IB_95827_SBT3.6A1_LB2.indb 44 26.09.14 13:22