Powerfix Z29948 - Manual (Page 31)

31 GB/MT
Safety Instructions / Getting started
area with plenty of clean water and consult a doctor
immediately.
J Remove light dirt from the battery and product con-
tacts with a dry, non-fluffing cloth before inserting the
batteries.
J Remove the batteries from the product if it is not in use
for any length of time.
J Make sure that the polarity is correct when you insert
the batteries. This is indicated in the battery compart-
ment. The batteries can otherwise explode.
J Insert the batteries with care. The product can other-
wise be damaged.
J Please do not dispose of used batteries in your house-
hold waste but take them to a designated collection
depot for special waste.
Q 
Getting started
Q 
Inserting / changing the batteries
j note: First remove the protective foil from the device.
j Open the battery compartment 5 on the back of the
appliance.
j Remove the used batteries if need be.
j Insert two new 1.5 V batteries (AAA) into the bat-
tery compartment 5 .
note: Ensure correct polarity. This is indicated in the
battery compartment
5 .
j Close the battery compartment 5 again.
Q 
Using the Multifunction Detector
tip! Test the device before initial use on a metal pipe
or power line whose position you know exactly.
j Slide the function switch 3 to “METAL” in order to
locate metal pipes etc.
j Slide the function switch 3 to “VOLTAGE” in order to
locate power lines etc.
j Hold the measuring head 1 directly on the desired
point of the wall.
j Press and hold down the PUSH key 4 .
j Move the device slowly over the wall surface.
note: Ensure direct contact between the measuring
head
1 and the wall.