Epson PowerLite 1715c - Manual (Page 85)

Presenting Through a Wireless Network 85
Using Presentation Mode
In Presentation Mode, the projector shows a black screen (or an image
of your choice) while you search for files or perform other activities on
your laptop. When you start a PowerPoint (Windows) or Keynote
(Mac) slide show, the projector shows your slides.
1. Click the Presentation Mode button on the NS Connection
toolbar. The projector displays a black screen with the Epson
logo.
2. Open your presentation in PowerPoint or Keynote.
3. In Keynote, select Preferences . Set the Presentation Mode to
Present on secondary display .
4. In PowerPoint, open the Slide Show pull-down menu and select
Set Up Show . Set the Multiple monitors box to Display slide
show on Monitor 2 . Then click OK .
5. Start your slide show. The projector displays your slides. When
you finish your slide show, the projector again displays a black
screen.
6. When you want to exit Presentation Mode, click the
Presentation Mode button on the NS Connection toolbar.
Using Presenter View
Presenter View allows you to see your PowerPoint notes and controls
on your laptop while projecting only the presetation slides to your
audience. Follow these steps to set up and use Presenter View:
1. Make sure you have at least one EPSON Virtual Display enabled.
If you did not enable Virtual Displays when you installed NS
Connection, select
EPSON Projector from Start > Programs or
All Programs . Select Add-Remove EPSON Virtual Display ,
then check EPSON Virtual Display 1 . If you see a message that
the driver has not passed Windows Logo testing, click Continue
Anyway . Then restart your computer.
2. Launch NS Connection as described on page 73.
note
If you want to display an
image or logo instead of a
black screen, you can replace
the image.jpg file in the
EMP NS Connection V2
\Image folder. In windows,
this is located in C:\Program
Files \Epson Projector \EMP
NS Connection V2\image.
In MAC OS X, it is located
in \Applications\EMP NS
Connection V2\Image.
Disconnect and then
reconnect to the projector
after you replace the image.