Epson PowerLite 1715c - Manual (Page 92)

92 Presenting Through a Wireless Network
4. Highlight On to receive email notifications, then press Enter .
5. Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used:127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
6. Enter the SMTP server’s port number. The default value is 25.
You can enter a numeric value from 1 to 65535.
7. Choose one of the Destination Address fields, then enter the
e-mail address and the contents of the message that you will
receive when an problem or warning occurs. You can register up
to three addresses. You can enter up to 32 alphanumeric
characters for the e-mail address.
8. Select problems or warnings to be notified about by mail.
When the selected problem or warning occurs, an e-mail message is
sent to the specified notification addresses. The subject line of the
e-mail is
EPSON Projector . The e-mail includes the following
information:
■ Line 1: The name of the projector where the problem has
occurred
■ Line 2: The IP address of the projector where the problem has
occurred
■ Line 3: Details of the problem
note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network ON in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).