Earlex IS2000 - Manual (Page 12)

HELPLINE NUMBER - TOLL FREE 888 STEAM 12. CALL FIRST IF YOU HAVE ANY PROBLEM
12
The Scraper Nozzle is ideal for very fast defrosting of freezers (check with freezer manufacturer), also
for jobs such as removing the dried on grass from lawnmowers. Remember that steam both cleans
and sanitizes at the same time. So on work surfaces you are ensuring these are really clean.
As an optional extra (Code M0605) we offer a pack
of 3 spare brushes each with different coloured
bristles so you can keep these for separate jobs
and always know which one to use.
Also available as an optional extra (Code M0625)
is a Brush Nozzle with wire bristles for cleaning barbeques.
GETTING STARTED
Before you use your Earlex Steam Dynamo Pro, make sure that you have read and followed all the
safety instructions.
Decide how you want to use the Steam Dynamo Pro as a hand held unit with the Steam Unit hung
over your shoulder, with the Steam Unit fixed to the Caddy free to be pulled along on the floor, or set
up as a Garment Steamer. Refer to the section “Preparing your Steam Dynamo Pro for use” and fit
together the various parts of the system to suit the job in hand.
Filling the Water Tank (8)
The Water Tank can be filled in two ways. Remove the Steam Handle from the
Holster then either:
Lift the Water Tank Lid (7) and hold it out of the way, fill the Water Tank to the
base of the filler neck (75cl) then replace the lid.
Or
Lift Water Tank Lid and pull the Water Tank out completely. Fill this from a faucet
to the base of the filler neck then replace it into the Steam Unit and replace the
lid.
Note In hard water areas we recommend you use cooled boiled water.
The water in the tank should last for about 30 minutes of cleaning time but this
can be refilled at any time and does not require the unit to be switched off. Nor
do you have to wait for it to heat up again. Simply refill either in situ or at the
faucet and you can continue as before.
USING THE MINI ATTACHMENTS
The 3 Mini Attachments are stored in a recess underneath the Steam Unit
for easy selection of the tool required. The 3 attachments supplied are:-
a) Scraper Nozzle (15)
b) Brush Nozzle (16)
c) Jet Nozzle (14)
WARNING: THESE MINI ATTACHMENTS RUN VERY HOT IN USE. When changing the Mini
Attachments, always use a cloth when holding the attachment to prevent burning your hands. Check
attachments on a regular basis for any debris/scale build up.
The Mini Attachments are ideal for cleaning stoves, baths, toilets, work surfaces, tiles, basins,
barbecues etc. The brush can be used to agitate areas that need that little bit extra abrasion. We
recommend that you use these attachments in conjunction with a damp cloth. As an example – if you
have baked on material on a stove, aim the Jet Nozzle at the surface, press the Steam Button to
release the steam and you should be able to easily wipe the surface clean. The damp cloth enables
you to wipe away the waste material.
a b c