Powerfix Z32114 - Manual (Page 77)

77 GB/MT
4. Press the + / = button again. The new meas-
urement is added to the old in the lower row.
5. Repeat steps 3 to 4 to add further measure-
ments.
6. Press the MODE button 4 to leave the
addition mode. All the measurements will be
deleted.
Measuring surface areas
1. Slide the function switch 9 to the position
„DISTANCE“. The display 2 is turned on.
2. Press the MODE button 4 once. The message
„L“ (length) appears in the display.
3. Press the READ button 6 to measure the
length. The measured length appears in the
upper row of the display and the message
„W“ (width) starts to blink.
4. Press the READ button to measure the width.
The measured width appears in the upper
row of the display. The results of the surface
area calculation appear in the lower row.
Addition of surface areas
1. Measure an area as described in the section
„Measuring surface areas“.
2. Press the M button 7 . The message „M+“
appears in the display 2 . The measured
surface area is saved.