Hotpoint Ariston SI E40 BA0 - Manual (Page 26)

26
it en
Automatic Stand-by
function (H
1
)
LCD
The automatic switch-off function guarantees total
safety.
This function automatically switches off the iron when
it is not used for a few minutes. In particular:
• the iron switches off automatically after 30
seconds when left unattended in the ironing
position or sideways;
• the iron switches off automatically after 10
minutes when left unattended in the rest position
(vertical).
If you leave the iron unattended, the display flashes a
green light and an acoustic signal is emitted to inform
that the automatic stand-by function is active.
Simply move the iron or press the temperature buttons
+/- (4a) to switch it back on.
Wait until the display becomes red before
starting ironing again.
Automatic switch-off
function (H
2
)
The automatic switch-off function guarantees total
safety.
This function automatically switches off the iron when
it is not used for a few minutes. In particular:
• the iron switches off automatically after 30
seconds when left unattended in the ironing
position or sideways;
• the iron switches off automatically after 10
minutes when left unattended in the rest position
(vertical).
If you leave the iron unattended an acoustic signal is
emitted to inform that the automatic switch-off function
is active.
Simply move the iron to switch it back on.
Wait until the temperature indicator light
turns off before starting ironing again.
CLEANING AND
MAINTENANCE
After use (I)
1. Set the steam regulator (3) to Off, disconnect the
appliance plug from the electrical socket and let
the iron cool down.
section “Selecting the temperature and adjusting
the steam”).
Ironing with shot of steam (E
2
)
The shot of steam function allows you to eliminate
persistent wrinkles. You can use this function both in
no-steam and steam ironing mode.
1. Check that the water level in the reservoir is
higher than ¼.
2. Select the recommended ironing temperature
with the temperature control (4b) (see step B
2
and chapter “Using the iron”, section “Selecting
the temperature and adjusting the steam”).
3. Press the shot of steam button (1) to obtain
an extra steam flow when ironing. If the shot
of steam function has not been used for some
time, it may be necessary to press the button
repeatedly to activate the pump.
FEATURES
Spray function (F)
The spray function is used to dampen the garment in
order to remove persistent wrinkles easily. You can
use the spray function both in no-steam and steam
ironing mode at any temperature.
1. Check that the water level in the reservoir is
higher than ¼.
2. With the iron in horizontal position, press the
spray button (2) to dampen the garment.
Vertical steam function (G)
The vertical steam function is useful to eliminate
wrinkles from hanging garments, curtains, etc. You
can use this function by simply placing the iron in
vertical position. All functions of the appliance will
remain unchanged also in this position (refer to
chapter “Use” according to the model).
Do not direct steam towards people or
animals and do not iron garments while
worn.
Anti-drip function
The iron is provided with anti-drip function in order to
automatically interrupt the steam distribution when the
temperature is too low, thus preventing water dripping
out of the soleplate.
Do not use steam with low temperatures
(see chart in step B
1
and B
2
, chapter “Using
the iron”, according to the type of iron you are
using).