Electrolux DISHLEX DX 103 - Manual (Page 8)

When the washing program operates, you can-
not change the program. Cancel the washing
program.
Warning! Only interrupt or cancel a washing
program if necessary. Open the door carefully.
Hot steam and water can escape.
Cancelling a washing program
• Press and hold the start/cancel button until the
start/cancel indicator light goes off.
The washing program is cancelled.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing program.
Fill the detergent dispenser with detergent before
you set a new washing program.
Interrupting a washing program
1. Open the appliance door. The washing program
stops.
2. Close the appliance door. The washing program
continues from the point of interruption.
End of the washing program
• The appliance stops automatically.
• The 'Finished' indicator light comes on.
1. Switch off the appliance.
2. Open the door.
3. For better drying results, keep the door ajar for
some minutes before you remove the dishes.
Let the dishes cool down before you remove them
from the appliance. Hot dishes are easily damaged.
Removing the load
• First remove items from the lower basket, then
from the upper basket.
• There can be water on the sides and door of the
appliance. Stainless steel becomes cool more
quickly than the dishes.
Care and cleaning
Warning! Switch the appliance off before you
clean it.
Cleaning the filters
Important! Do not use the appliance without the
filters. Make sure that the installation of the filters is
correct. Incorrect installation will cause unsatisfactory
washing results and damage to the appliance.
1 2
Fully clean the filters A,
B and C below running
water.
3
To remove filters B and
C, turn the handle ap-
proximately 1/4 anti-
clockwise.
4
Remove the flat filter A
from the bottom of the
appliance.
8