Electrolux DISHLEX DX 103 - Manual (Page 9)

5
Put the filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
6
Put the filter system in
position. To lock the fil-
ter system, turn the han-
dle clockwise until it
locks in position
Important! Do not remove the spray arms.
If the holes in the spray arms become clogged, re-
move remaining parts of soil with a cocktail stick.
External cleaning
Clean the external surfaces of the appliance and con-
trol panel with a damp soft cloth. Only use neutral de-
tergents. Do not use abrasive products, scouring
pads or solvents (acetone etc.).
Internal cleaning
Do an inspection at intervals of 3 months. Set a
washing program for heavily soiled dishes. Use de-
tergent, but do not put dishes in the appliance.
Long periods of non-operation
Do these steps when you do not use the appliance
for a long period:
1. Disconnect the mains plug from the mains sock-
et.
2. Close the water tap.
3. Keep the door open to prevent unpleasant
smells.
4. Keep the inner side of the appliance clean.
Frost precautions
Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is
not responsible for damage because of frost.
If not possible, empty the appliance and close the
door. Disconnect the water inlet hose and remove
water from the water inlet hose.
Moving the machine
Do these steps to move the appliance:
1. Disconnect the mains plug from the mains sock-
et.
2. Close the water tap.
3. Remove the appliance and the hoses.
4. Do not tilt the appliance during transport.
What to do if…
The appliance does not start or stops during opera-
tion.
If there is a fault, first try to find a solution to the prob-
lem yourself. Refer to following charts. If you cannot
find a solution to the problem yourself, contact your
dealer or the Customer Care Centre.
Warning! Switch the appliance off before you
do the suggested corrective actions.
9