Extron Electronics MTP U R RS - Manual (Page 14)

MTP U R Series • Installation
Furniture or projector mounting
Use the optional mounting kit (MBU 123, furniture,
part #70-212-01, or PMK 100, projector, part #70-217-01) to
mount the MTP as follows:
MT P S ER IE S
INPUT
OUTPUT
PO
WER 12V .5A MAX
M T P R 1 5 H D A
ON 1 2 3 4 5 6 H SYNC +
V SY NC + C SYNC
SOG
VIDEO
SP
ARE
1 MONO A
UDIO 2
Projector
Pole
Mount
Kit
Mounting
Bolt
Figure 11 — Desk and projector mounting the MTPs
1 . Remove the feet from the bottom of the MTP, if they are
installed.
2 . Attach the mounting brackets to the MTP with the machine
screws provided.
For furniture mounting
3a . Hold the MTP with the attached brackets against the
mounting surface. Mark the bracket screw hole locations
on the mounting surface.
3b . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
3c . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" (6 mm) of the screw head protrudes.
3d . Align the mounting screws with the slots in the brackets
and place the MTP against the surface, with the screws
through the bracket slots.
3e . Slide the MTP slightly forward or back, then tighten all four
screws to secure the MTP in place.
For projector mounting
3 . Attach the MTP to a projector mount by inserting the
mounting bolt through the pole mount’s slotted hole and
secure. in place
11