Medal Sports 78201 - Manual (Page 5)

5
ASSEMBLY INSTRUCTIONS
BADMINTON SET
ITEM 78201-14
FIG. 6
5. NET SET UP
A. Stretch the assembled net and poles across the playing area until the net is taught. Press the pole anchors
into the ground where the poles touch ground. Slip the poles onto the anchors. Holding the poles in vertical
position, press the guide rope stakes into the ground at a 450 angle,3 FT to 5 FT from the pole and 3 FT to
5 FT apart. Make sure the hooks on the stakes are facing away from the poles. See FIG. 5.
6. BOTTOM GUIDE ROPE SET UP
A. Make loop on bottom guide rope tension clip large enough to slip over stake already in ground.
Make sure guide rope loop is placed under stake hook. See FIG. 6.
3 FT - 5 FT 3 FT - 5 FT 3 FT - 5 FT 3 FT - 5 FT
FIG. 5
Guide Ropes
Second Guide Ropes
FIG. 6A
TIP: After the net is assembled,
you can adjust the pole tension
by sliding the tension clips up or
down along the guide ropes.
Top
Guide Rope
Ground
stake hook
Bottom Guide
Rope
TIP: After the net is completely assembled
and the pole tension is tighten and fixed,
adjusted the tension clip up or down along
the top cable and the locking cord of bottom
cable to tighten the net.