Meliconi Gumbody Facile Light - Manual (Page 3)

To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
ADDITIONAL CHECK
Point the remote control at the TV. Check that the TV responds correctly to the commands given. If there
is no response or the TV only responds partially or incorrectly, it is probable that you have used the wrong
code. In this case, repeat the procedure starting from point 3. This time, however, use the
NEXT CODE
in the list (e.g. 1006).
The quickest and easiest way to programme the remote control
is by consulting the website www.gumbodylight.com .
D I R E C T C O D E E N T RY
B
1. Switch on the TV.
2. Look for the brand of your TV in the code book and
make a note of the first code in the list (e.g. Philips
1000).
3. Hold down the MUTE and ON/OFF buttons together for
5 seconds until the light indicator at the top starts to
flash indicating that the remote control is being
programmed.
4. Release the buttons and enter the 4-digit brand code
previously identified (e.g. 1000) within 12 seconds.
Three flashes indicate that the code has been
memorized correctly. If not, try the code entry procedure
again, starting from point 3.
PHILIPS 0025
TV 1000 1006 1007 1008
1009 1010 1011 1012 1013
1014 1015 1016 1017 1018
Remember to make a note of the TV code used to programme
the remote control on the adhesive label inside the battery cover
for quick and easy reprogramming.
N.B. THE LIGHT INDICATOR STOPS FLASHING
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if an invalid code is entered
N.B. THE LIGHT INDICATOR STOPS FLASHING
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if an invalid brand code is entered
• if the end of the code search list has been reached. In this case, switch to programming mode C .
+ + + 1 0 0 0
+
5 SEC.
9